a2z MagCap Single Guide Jig

The a2z MagCap Single Guide Jig is for use with the a2z Universal Base, as part of the a2z laser jig system.

How the a2z jig system works

This jig works with the a2z Universal Base. The system is simple: the base mounts to your laser bed once and gets centered once — that's the only alignment you ever do. After that, this jig and every other a2z insert locate to that same base and land in exactly the same spot, every time. Switch from flat stock to coins to tumblers in seconds, and the engraving files you've already dialed in keep lining up without test marks or re-framing.

1. Mount the Universal Base once. One-time setup, centered on your laser.
2. Set this jig on the base for today's job. Same base, same position, as every a2z insert.
3. Engrave with repeatable positioning. No re-alignment between jobs — ever.

The alignment edge is aligned with the edge of the bounds of the 150mm insert. The jig can be attached in any orientation on the Universal Base in 90 degree increments so the edge can be on top, bottom, left or right side.

Runs on the a2z Universal Base (shown in photos, sold separately) — add the Universal Base once and every a2z insert jig you buy after it clicks in with zero re-alignment.